Never grind on the side of a grinding wheel unless it’s specifically advertised as being design/rated for side loading. Do not sharpen HSS with Silicon Carbide or Diamond wheels. For sharpening HSS bits, use aluminum oxide wheels only (bench grinder with one coarse and one fine aluminum oxide wheel). (bench grinder with each wheel type per end). I think that attention to the final honing would help you enormously.įor sharpening brazed carbide bits, use a green Silicon Carbide wheel for rough shaping, and a Diamond wheel to dress the finial cutting edge. If you want to make turnings which are barely dust and your work shine as well as 'mike' try Walshawand Hoffman. Conrad Hoffman - I've mentioned him before- gives a blow by blow discourse in his Advanced Tool Sharpening site. I would seriously suggest that you 'black in' the little bit with a waterproof marker and hone it away with diamond paste or film. The little amount of effort required to make and use them means that if they don't suit you that you haven't lost much.Īgain, I strongly suspect that your previous efforts have been thwarted by your failure to do as Tom Walshaw wrote as Tubal Cain, it is all to do or not to do with that little bit at the end of the tool that matters. I've been over the text etc and - whilst I may take issue about the Deckel clone, you would benefit from the two simple jigs as starting points. However, I would suggest that you read and absorb John Moran's 's web pages. There is precious little to fault Hall's book except that things are changing and probably adding diamond and CBM would help you enormously. I'm really going back to your previous dilemmas with boring tools - or whatever.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |